110 Volt Electrical Done

My 110 volt wiring is complete. It’s all on the interior of the trailer, not inside the walls. I did it this way so that I didn’t have to notch out the 1×2 framing, I didn’t interfere with the insulation, and I didn’t take the chance of hitting it with a nail or screw after it was inaccessible. The wiring runs are mostly inside of the cabinets behind drawers or protected by false shelves.
wire hiding
I cut down a shower curtain pole to run the wiring from the upper kitchen cabinets down to the lower cabinet and I used two metal surface mounted boxes with metal raceway for the wiring that I couldn’t conceal.
The circuit protection is a huge upgrade from the original ceramic fuse block (that’s the original fuse block sitting there between the outlet and the power cord).
Shasta Breaker Box
I used a 100 amp 6 space 12 circuit Square D load center with a 30 amp main breaker and 4 – 15 amp circuits. It’s located just inside the roadside rear hatch. I can finish the interior in well lit air conditioned comfort now.
Shasta lights
Got some glare and reflections on that picture… hey, there’s my teardrop!

Back to the 1956 Shasta page: 1956 Shasta

Advertisements